Browse Categories

Small 10 mm I.D. Dry Pellet Pressing Die For Hi-throughput Pressing - EQ-Die-10S

In stock
Item Number: Die10-S
EQ-Die-10S is a small size pressing die with 10 mm I.D. for high-throughput pressing by a 100T hydraulic press machine, which can press 32 pcs pellet at one time.

Pressing die installation schematic
  • To avoid the risk of accidents and damage to the Pressing Die, please read these instructions carefully before installation and before using it for the first time.
    1. Must Read the manual especially the die installation schematic before the operation.
    2. The operator must wear protective goggles.
    3. Must have Hydraulic Pellet Press equipped with the Protection Cover   
Material Made by High-stretched Carbon Steel 
Hardness HRC 60-62
Roughness Average (Ra) 0.08 μm
Maximum Load 5 metric Ton (at room temperature)
630 MPa
Weight 0.4 Lbs

The whole set  pressing die includes
  • One 10mm  I.D. core die 
  • One steel sleeve for the core-die protection
  • Two pushing rods highly polished and perfectly fitted into the die.


    • Must put die in the center of pressing machine, otherwise  may make the pushing rod cracking.
    • DO NOT press flammable, corrosive, or explosive materials
    • The operator must wear a protection goggle.
  • Attention:
    • Use ethanol to clean the pressing die before and after use every time
    • Use anti-rust oil after the operation and store it in a dry place to avoid rusting.
    • NO pressing powder with particle size LESS THAN 30 micron should be used. Small particles may slip into the gap between the pushing rod and steel sleeve and cause damages to the sleeve during the compression.
    • Ball mill or ground the powder to the size of 32~75 microns powder before pressing.
    • You may consider using EQ-BNMR for easy mold release. Please click the picture below to order.
    • .  

Instruction Video


Steps to make sample pellet
  • Mixing and grinding chemical powder by agate mortar or Ball Mill
  • Calcine mixed the powder in a high temp furnace under suitable temperature
  • Crushing and Grinding calcined powder again by mortar or ball mill
  • Put calcined powder into the die
  • Pressing sample by a pressing machine under suitable pressure
  • Take out pellet sample from die
  • Sintering the pellet under suitable temperature in Oven
  • Then, a new material sample is formed!
  • Pressing Dies are consumable products and are not covered by MTI's warranty.

Related Products

Pressing Die  1/8" - 3" 
Laboratory Mill & Mixer
Powder grinding & Mixing
Gravity Convection Ovens, Max. 300C
Drying Ovens

Calcining & Sintering

Hydraulic Press

CIP - Cold Isostatic Press

Related Products

Shopping Cart
Your cart is empty.
Please clear the browsing history before ordering the product. Otherwise, availability and price are not guaranteed.
Mailing Lists
MTI sponsorships:
MTI Sponsors Thermoelectrics Workshop

MTI-UCSD Battery Fabrication Lab

MTI Sponsors the Postdoctoral Awards

Upcoming Shows:

245th ECS Meeting May 26-30 San Francisco CA Booth 108

Hydrogen Tech Expo June 26-27 Houston TX Booth 567

2024 MRS Fall Meeting December 1-6 Boston MA Booth 901

AABC US December 9-12 Las Vegas NV

Click here to see our past conferences

1. Prices listed online are valid for the US market and who pay by credit card only. There will be extra charges for shipping & handling. Prices vary from country to country.
2. We may add extra charges for paper orders and NET 30 terms due to extra labor costs.
3. The prices listed are subject to change without notice.