1700C Bench-Top High Temperature Furnace (8 x 8 x 8") with Evaporating Particle Collection - KSL-1700X-SJ

Furnace Structure

• 1700 grade fiber alumina with reflective coating - max energy-saving design
• Double layer steel structure with air cooling fan to keep case temperature below 60°C
  
• A square alumina crucible with lid inside the chamber
• Alumina tube on the left and top of the furnace for gas inlet/outlet from the alumina crucible
• A water chiller placed on top of the furnace for separating and collecting colloid

• Chamber: 200mm L x 200mm W x 200mm D (8 x 8 x 8 inch), 8.4 Liter
• Alumina Crucible: 90mm L x 90mm W x 140mm H
• Overall: 755mm L x 530mm W x 1,040mm H

Power

5.2 KW

Voltage

AC 208V-240V single phase, 50/60 Hz (32A air breaker required)

Standard Working Temperature

1650°C or 2912°F (continuous)

Maximum Working Temperature

1700°C or 3092°F (< 0.5 hours)

Heating Rate

10°C/min (< 1400°C)
5°C/min (1400°C - 1600°C)
2°C/min (> 1600°C)

Temperature Accuracy

+/- 1°C

Heating Elements

Thermocouple

Temperature Controller

• FA-YD518P-AG temperature controller is included
• Proportional–integral–derivative control (PID control) and auto-tune function
• 30 segments programmed with ramping, cooling and dwelling steps
• Built-in over-temperature alarm and thermocouple failure alarm
• +/- 1ºC temperature control accuracy
• Default DB9 PC communication port

• MTS02-Y Temperature control software kit (for YD518P series controllers) + 15" laptop package is available at the options bar. Click for the detail information about the MTS02-Y software kit
  
• You may upgrade the temperature controller to the Eurotherm 3504 Temperature Controller which is fully compatible with LabVIEW. This package includes a Eurotherm 3504 programmer, a communication cable (RS485 - USB) and a software CD. Click the pic below to view the full spec of Eurotherm 3504 temperature controller

Net Weight

150 kg

Warranty

• One year limited warranty with lifetime support.  (Consumable parts such as sample plates and heating elements are not covered by the warranty, please order the replacement at related products below.)
• ATTENTION: Any damages caused by the use of corrosive and acidic gases are not under the coverage of MTI One Year Limited Warranty.

• CE Certified
• NRTL or CSA certification is available upon request at an extra cost
  

• For longer furnace service life, we recommend the heating rate not to exceed 10°C /min
• The cooling rate shall also not exceed 10°C /min
  
• This furnace lacks vacuum sealing, toxic or explosive gases are not recommended for use with this furnace without necessary safety controls and supervision
  
• Small cracks may appear on the surface of the refractory ceramics over extended use. This is a normal occurrence and the cracks may be repaired with alumina coating
  
• Please click here to learn how to DIY gas purging system
  
• The refractory block must be inserted before closing the door