Dual Explosion-Proof Box for Battery Safety Test ( 20"x20"x20", 125L, UN38.3.4.7 & 8 ) - MSK-TE903

Power

Structure & Material



          

• Materials:    
• Chamber:  1.5 mm thick brushed SS304  with tensile strength > 500 Mpa
• Exterior:    3 mm thickness cold rolled steel with tensile strength > 400 Mpa

• Structure:            Two anti-explosion chambers, top and bottom
• Chamber Size:     500mm x 500mm x 500mm (x2)
• Testing Cables:    Two 3 meters long cable with clamp are included, Max. current rating is 30A 
• Ports:                  Each chamber has two 2" diameter holes reserved for electric cables of battery testing equipment
• Safety door: The pressure relief door is built on the back of each chamber. In the event of a battery explosion, the door will open and release pressure. 

                         

• Note:  The max. capacity of Li-Ion batteries to be tested in the chamber should be limited to 4.2V@ 40Ah for single-cell  or 160Wh for battery pack without protection circus

Venting Fan

• Venting port with high-quality exhaust fan is installed in the back chamber which shall be connected to your venting system. (ducting and exhaust system are not included )
• Warning:  Must keep venting fan and exhaust system running during battery testing to avoid pressure build-up in the case of a battery explosion.
  
• Venting fan: 24 VDC, 3425 RPM, 235 CFM, 54.3 dBA
• Centrifugal in-line exhaust fan with aluminum flex duct connection is recommended but not included.
  
• If you need control chamber temperature between 23oC - 46oC, we may help you to install a spot air conditioner ad the picture below, at the extra cost

          

Lighting

• Anti-explosion LED light (30W) is installed inside of each chamber. 
• The angle of illumination is adjustable up to 90°

Electrode Holder & Cables

Mobility 

Net Weight & Dimensions

• 220 kg
  
• L700mm x W630mm x H1800mm

• 620 lbs
• 48"x40"x88"
  

• IEC 62133 Safety Test Standard Details
• Please click here to review the UN38.3 Li-Ion Battery Transportation Safety Testing Requirements
• Other equipment for testing of IEC 62133 or UN38.3 Standards can be found at http://www.mtixtl.com/batterytestequipent.aspx