• Quick test procedure for MTI furnaces (pdf)
• How to use MTI furnace controller
• How to Install Hinge Flanges
• How to attach power to high-power furnace (for the USA) (pdf)
• How to install temperature controller into MTI’s furnaces (pdf)
• How to install solid trigger into MTI’s furnaces (pdf)
• How to set up ceramic tube and vacuum flanges (doc)
• How to change 32A fuse on MTI furnaces (doc)
• How to calibrate tube furnaces (pdf)
• How to insert and remove Thermo block(video)
• How to install tube for GSL-1700X-VT (video)
• How to use and maintain Alumina tube (pdf)
• How to check and replace heating element for OTF-1200X series tube furnaces (doc)
• How to install MoSi2 heating elements (video)
• How to install SiC heating elements (video)
• How to install heating elements in OTF-1500X-II-R60 (video)
• How to install the Continuous Powder Feeding & Retrieving System for OTF-1500X-II-R60-AF-UL (video)
  
• How to install heating elements in GSL furnaces (video)
• How to seal vacuum system (pdf)
• Where to place Thermo block for GSL series furnaces
• How to modify the thermal blocks
• Thermoblocks placement for GSL series(PDF)
• Thermoblocks placement for OTF series(PDF)
• How to check and replace heating element for OTF-1600X-III tube furnaces 
• How to check MTI (SSR)Solid State Relay(PDF)
• How to install Installing the Gas Purging Adaptor

Electric diagram: KSL-1600X (jpg)

How to maintain and repair SiC heated furnaces (KSL-1400X, etc)

• SiC heating element's resistivity will increase when operating at high temperature, which will result in furnace power reduce; the meaning temperature will not reach to more than 1300^oC. In order to keep longer service life of SiC heating element, you need to rewire SiC heating element with SiC resistivity increases from
• 5 series and 2 parallel connection (new) (5S2P)
• 2 series and 5 parallel connection (middle life) (2S5P)
• 1 series and 10 parallel connection (old) (1S10P)
• If 10P still can not give you enough power, you need to change SiC heating element  and start from 5S2P connection
• Please click here to see diagram  on how to change wiring from 5S2P to 1S10P
• Please be advised if furnace chamber cracked, you shall repair them using Al2O3 adhesive (click to order). If crack is too larger, you shall use high-temperature Al2O3 fiber to fill the cracks first, then put ceramic coating

• How to change round belt in the MD-10 XRD (pdf)

• Basic procedure for preparing metallographic specimen (doc)
• Troubleshooting unipol-300
• Polishing machine applications
• Blade saws applications
• Wire saws applications
• STX-202 controller case disassembling (video)
• How to replace the main board of MSK-SFM-8 (video)